How To Make The Unlock Character Button Opacity At 0

Discussion in 'How Can I...?' started by Le 'Dog Sauce' Monroe, Aug 14, 2017.

  1. Le 'Dog Sauce' Monroe

    Le 'Dog Sauce' Monroe Boxer

    Joined:
    Feb 8, 2017
    Messages:
    29
    Likes Received:
    0
    Hi, so my question is how to make the unlock character button opacity be transparent (0).

    I'm trying to put a character unlock button behind a navigation button that leads to a level where that character will be used, but when it loads, you can see the character behind the navigation button before it's covered up, by that same navigation button.

    How do i make the character unlock button opacity at 0 so that it doesn't show up. Now i know the obvious answer would be to set the opacity at 0 (duh), but thing is, it won't be transparent. You can still see it. It's like it's still at 1, but it says 0.

    I'll attach a screenshot to give you an idea of what i'm talking about for those of you who don't understand.

    Screen Shot 2017-08-14 at 8.02.30 PM.png
    Ok, that right there clearly shows that the opacity has been set to 0.

    Screen Shot 2017-08-14 at 8.02.45 PM.png

    Then this right here is a screenshot of what it looks like on buildbox. The unlock button is transparent.

    Screen Shot 2017-08-14 at 8.03.01 PM.png
    But then this is what it looks like on preview, and when i was testing it out on the simulator on xCode a while back.

    So how do i make that little square transparent?
     
    Last edited: Aug 14, 2017

Share This Page